LED Display Description Action
HD LED flashing
green
Hard disk access –
LED is flashing
green (with a
flashing
frequency of
approx.
2 Hz)
1)
Warning: SMART analysis is identifying
errors.
Observe that this warning message is not
displayed if RAID is used
Exchange hard disk
Reset LED is red Monitoring LED for the “Reset” button. The
LED is on as long as the “Reset” button is
pressed
–
Tab. 12-1: LEDs for operating and error display on the connector panel
Wrong initialization of the CDI interface and no
image output at the connected display VDP xx.3
if the input voltage has been switched on too
early
If the control cabinet PC is shut down under Windows and the 24 V input
voltage is switched off, the input voltage can only be switched on again when
the V
IN
LED is off.
13
Error causes and troubleshooting
For information on the error display on the front panel, refer to chapter 12.1
"Operating and error displays" on page 43.
Errors
Troubleshooting
Wrong display resolution ● Set the correct display resolution in the
graphics driver
● Restart the control cabinet PC
The device switches off unintendedly Check the max. current consumption of the
connected USB devices
1)
Provided that the IPC Service program (IPCSvc) is installed
44/57
Error causes and troubleshooting
IndraControl VPB 40.4
Bosch Rexroth AG R911376309_Edition 02
To Next Page
Loading...
