Fig. 10-11: Removing the control from the top-hat rail
The control bus base remains on the mounting rail.
Demounting the control bus base
1. Separate the bus base module of the control from the connection of the
first S20 bus base by moving the bus base of the control to the left by ap-
proximately 5 mm, see "A" in the following figure.
2. Separate the bus base of the control from the connection of the first exten-
sion bus base by moving the bus base of the control to the right by approx-
imately 5 mm.
3. Use a suitable tool (e.g. slotted screwdriver) to enter into the latchings on
one side, see "B", "B1" and "B2" in the following figure.
4. Lift up the bus base and remove it, see "C" in the following figure.
Fig. 10-12: Removing the control bus base from the top-hat rail
24/65
Mounting, demounting and electric installation
IndraControl XM42 Controls
Bosch Rexroth AG R911345566_Edition 03
To Next Page
Loading...
