4 Identifying the Control Section
4.1
Type Plates
4.1.1 General Information
Each drive component is marked by a type designation.
There is a type plate attached to all devices.
4.1.2 Type Plates at the Drive Controller
1 Power section
2 Control section
3 Firmware
4 Control panel
Fig. 4-1: Type Plates at the Drive Controller
DOK-INDRV*-CXX02******-PR03-EN-P Bosch Rexroth AG 25/143
IndraDrive Control Sections CSB02, CSE02, CSH02, CDB02
Identifying the Control Section
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com