6-80 Drive Control MPH-02, MPB-02, MPD-02
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
• E8058 Drive system not ready for operation
• F2026 Undervoltage in power section
• F2086 Error supply module
• F2087 Module group communication error
• F2814 Undervoltage in mains
• F2816 Softstart fault power supply unit
• F2817 Overvoltage in power section
• F2818 Phase failure
• F2819 Mains failure
• F2820 Braking resistor overload
• F2821 Error in control of braking resistor
• F2825 Switch-on threshold braking resistor too low
• F2828 DC bus voltage, no mains
• F2833 Ground fault in motor line
• F2834 Contactor control error
• F2836 DC bus balancing monitor error
• F2838 Overcurrent external braking resistor
• F2840 Error supply shutdown
• F2860 Overcurrent in mains-side power section
• F8838 Overcurrent external braking resistor
Possible Device Combinations and Mains Connection
Note: The possible device combinations are only described in
principle for the purpose of explanation. As regards
combinations of device types actually possible and specific
facts to be observed, see the hardware documentation
(Project Planning Manual) of the respective device!
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
