4. General settings
Fig. 12-17: MLC commissioning wizard: Step 1
Device name, comments on the project as well as information on the
author are stored in the dialog "Step 1: General settings". To continue with
the configuration, press Next>>.
5. Hardware and communication
The MLC control to be projected is configured in "Step 2: Hardware/
communication". Select “Device type”, “Firmware version” and “Firmware
release” under “Device configuration”.
Bosch Rexroth AG
Device description
IndraControl VPB 40.4
64/87
DOK-MLC***-INDRACTRLV4-IT02-EN-P
To Next Page
Loading...
