Bosch rexroth M1-16 Series - Property Damage and Product Damage

RE 64025-B/2021-08-12, Bosch Rexroth AG
General instructions onproperty damage and product damage | Control blocks for mobile applications 15/54
3 General instructions onproperty
damage and product damage
The following safety instructions apply forchapters6 to14.
NOTICE
Danger from improper handling!
Product can bedamaged!
 Do not expose the product toany mechanical, hydraulic orelectric loads
under any circumstances.
 Never use theproduct ashandle orstep.
 Do not put/place any objects onthe product.
 Do not use sensitive assembled parts (e.g. actuation elements, sensors,
solenoids, or valves) for transporting the control block.
 Carefully place the control block onto the contact surface to prevent it from
being damaged and secure it against falling.
 Do not set/place the control block onto the actuation elements.
 Do not hit sensitive assembled parts (e.g.sensors, solenoids oractuation
elements).
 Do not hit sealing surfaces (e.g. onthe work connections).
 Leave the protective covers on the control block until you connect the lines.
 Disconnect all electric connectors before any painting operations.
 Ensure that the electronic components (e.g.sensors) are not electro-statically
charged (e.g.during painting operations).
Risk ofproperty damage due toinadequate lubrication!
Product can bedamaged ordestroyed!
 Always commission the control block with sufficient hydraulic fluid.
 When commissioning a machine/system, make sure that the housing area and
the suction and working lines of the control block are filled with hydraulic
fluid and keep them filled during operation.
Ingress offluids and foreign particles due tolacking sealings and locks!
Loss ofthe protection class and danger ofshort circuit!
 Before the assembly, ensure that all sealings and locks ofthe plug-in
connection are tight.