Bosch rexroth M1-16 Series - Transport and Storage; Transporting the Control Block

RE 64025-B/2021-08-12, Bosch Rexroth AG
Transport and storage | Control blocks for mobile applications 21/54
6 Transport and storage
 Always observe the required ambient conditions for transport and storage,
seeChapter6.2 "Storing the control block" on page23.
Deviations lead toearly aging ofcomponents and shortening ofservice life.
Notices onunpacking can befound inchapter7.1 "Unpacking" onpage25.
6�1 Transporting the control block
The following optional means oftransport can beapplied depending onthe weight
and duration oftransport:
• Transport byhand
• Transporting with alifting device (eye bolt orlifting strap)
The dimensions and weights vary by equipment. The values that apply to your
control block can be found in the offer drawing and the datasheet.
6�1�1 Transport byhand
Up toaspecific maximum weight, control blocks can betransported by hand
forashort distance. Observe the national regulations inyour country.
CAUTION! Danger due toheavy loads!
When carrying control blocks, there is a danger of health damage.
 Only manually transport the control block for a short period of time. Observe
the national regulations inyour country for manual transport.
 Always use appropriate lifting, lowering and moving techniques.
 Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
 Do not use sensitive assembled parts (e.g. sensors or valves) for transporting
the control block.
 Carefully place the control block to prevent it from being damaged.
6�1�2 Transport with lifting devices
For transportation, the control block can be attached to the lifting device via the
attachment points on the housing or via a lifting strap.
Possible attachment points are:
• The fastening threads of the connection flanges
• Mounted eye bolts according to DIN580.
 If necessary, screw an eye bolt fully into the attachment point. The thread size
isindicated inthe installation drawing.
 Make sure that theeye bolt can bear thetotal weight ofthecontrol block
plus20%.
Transporting with eye bolt