Bosch rexroth M1-16 Series - Installation

RE 64025-B/2021-08-12, Bosch Rexroth AG
Installation | Control blocks for mobile applications 25/54
7 Installation
Prior toinstallation, thefollowing documents should be tohand:
• Offer drawing (installation drawing) for the control block (can be obtained from
your contact at BoschRexroth)
• Hydraulic circuit diagram for the control block (can be found in the offer
drawing)
• Hydraulic circuit diagram for the machine (available from the
machinemanufacturer)
• Order confirmation (contains the order-related technical data for your
controlblock)
• Control block datasheet (contains the permissible technical data)
7�1 Unpacking
CAUTION! Danger due tofalling parts!
If thepackaging isnot opened correctly, parts may fall out and damage theparts
oreven result ininjury.
 Place thepackaging ona level underground with sufficient load-bearing
capacity.
 Only open the packaging from the top or at the provided location.
1� Remove the packaging from the control block.
2� Check the control block for transport damage and completeness, see chapter4
"Scope of delivery" on page18.
3� Dispose ofthepackaging inaccordance with theregulations inyour country.
4� Return any reusable packaging tothe corresponding sending
BoschRexrothplant.
7�2 Painting the control block
Perform the following steps if the control block is to be painted before installation:
 First protect the hydraulic ports by completely screwing on plastic threaded
plugs to avoid application of paint.
 Screws have tobe inserted into the fastening threads toprevent ingress
ofpaint.
 Carefully mask the flange surfaces of the control blocks and the port plates and
end plates before painting to prevent paint and dirt from entering.
 Prevent any paint being applied tothe contacts ofthe electrical connections
and make sure that the connectors are not damaged.
 Protect assembled parts (e.g. actuation elements, sensors, solenoids) to avoid
application of paint.
 Protect plastic and rubber parts from paint being applied.
 When removing the protective plastic threaded plugs after painting, make sure
that no paint chips enter the control block.
 Protect name plates against application ofpaint using afilm that can bepeeled
off after painting.