Bosch rexroth M1-16 Series - Installation: Assembly and Mechanical Connection

28/54 Control blocks for mobile applications | Installation
Bosch Rexroth AG, RE 64025-B/2021-08-12
Series Dimension Property class Tightening
torque [Nm]
Screw-in depth
[mm]
ROM8 M8 8.8 / 10.9 27 / 40
1)
RS12 M8 8.8 / 10.9 27 / 40 12
RS14 M10 8.8 / 10.9 54 / 79
1)
RS15 M10 8.8 / 10.9 54 / 79 18
RS20 M12 8.8 / 10.9 93 / 137 12…15
SM12 M8 8.8 / 10.9 27 / 40 10
1)
SP-08 M8 8.8 / 10.9 25 / 30 10 … 14
1)
SX10 M8 8.8 / 10.9 27 / 40
1)
SX12 M10 8.8 / 10.9 54 / 79
1)
SX14 M10 8.8 / 10.9 54 / 79
1)
¹
)
Through bore in housing; the screw-in depth depends on nut thread material.
7�5�5 Completion ofassembly
1� Remove any attached transportation aids.
CAUTION! Operation with protective plastic plugs!
Operating the control block with protective plugs may result in injury or damage
tothe control block.
 Before commissioning, remove all protective plugs and replace them with
suitable line connections or pressure-proof, metal threaded plugs.
2� Remove thetransport protection.
If necessary, the control block may be delivered with protective covers and
protective plugs. They are not pressure-resistant and have tobe removed prior
toconnection. Use asuitable tool for this toprevent damage tothe sealing and
functional surfaces. If sealing or functional surfaces are damaged, contact your
BoschRexrothservice partner or the service department of the manufacturer's
plant for the control block.
Ports intended for connecting lines come with protective plugs orthreaded
plugs, which serve astransport protection. All ports required for the function
must be connected. Failure todo socould lead tomalfunctions ordamage. If
aport isnot being used, it is to be pluggedwith athreaded plug since
theprotective plugs are not pressure-resistant.
7�5�6 Connecting the control block mechanically
Connection ofactuation elements including tolerances isillustrated inthe offer
drawing. The tightening torques are tobe selected according tothe actuation
elements. There must not occur any radial forces during actuation!
 At commissioning, make sure that the tongue is in the zero position
(controlspoolin the central position).