32/54 Control blocks for mobile applications | Installation
Bosch Rexroth AG, RE 64025-B/2021-08-12
To connect the pressure relief/feed valve to the hydraulic system:
1� Remove the protective plug or screw plug from the adjustment screw
.
2� Make sure that the sealing surfaces of the fitting are not damaged
3� Turn the screw fitting clockwise into the thread of the adjustment screw
.
When doing so, counter the lock nut
and the adjustment screw with an
open-end wrench.
4� Tighten the screw fitting correctly (observe tightening torque!).
Procedure
To Next Page
Loading...
