Bosch Rexroth MTA 200 - Page 108

Terminal Signal designation IBS data bit Note
2.7 not assigned 14
2.8 not assigned 15
2.9 Spindle speed = 0 0 1
2.10 Spindle ramp 1 1
2.11 not assigned 2
2.12 not assigned 3
2.13 not assigned 4
2.14 not assigned 5
2.15 not assigned 6
2.16 not assigned 7
* Input addressable via analog C commands (see LINPOS)
1 Active signal level = High (1)
0 Active signal level = Low (0)
Fig.8-23: Output signal assignment
106/135 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MTA 200 | Project Planning Manual
NC Multifunction Card NCM02