Bosch Rexroth MTA 200 - Page 80

Primary / Secondary Master / Slave
Type Primary Master: Auto
Primary Slave: Auto
Secondary Master: Auto
Secondary Slave: Auto
CHS Format
Cylinders Display depends on the IDE device
Heads Display depends on the IDE device
Sectors Display depends on the IDE device
Maximum Capacity Display depends on the IDE device
LBA Format
Total Sectors Display depends on the IDE device
Maximum Capacity Display depends on the IDE device
Multi-Sector Transfer Display depends on the IDE device
LBA Mode Control Enabled
32-bit I/O Enabled
Transfer Mode Display depends on the IDE device
Ultra DMA Mode Display depends on the IDE device
Fig.6-7: "IDE Device" submenu
Keyboard Features
NumLock: On
Key Click Disabled
Keyboard auto-repeat rate 30/sec
Keyboard auto-repeat delay ½ sec
Fig.6-8: "Keyboard Features" submenu
Boot Options
Boot-time Diagnostic Screen: Enabled
QuickBoot Mode: Enabled
Summary screen: Disabled
Boot with keyboard Disabled
Floppy check: Disabled
Hard Disk Pre-Delay: Disabled
Extended Memory Testing: Just zero it
Fig.6-9: "Boot Options" submenu
Advanced Menu
Installed O/S Other
Reset Configuration Data: No
Large Disk Access Mode: DOS
Small LBA-Disk CHS Translations: No
78/135 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MTA 200 | Project Planning Manual
PC CPU Configuration -55