Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS - Page 477

ECODRIVE03-FL*-04VRS Index 17-7
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Load default values 12-64
Load error LCA 12-33
Loading not allowed in phase 3 4-14
Loading not allowed in phase 4 4-14
Load-side motor encoder with inductance motor only 12-38
Locked with password 12-41, 12-42
Logic Task 7-1
Logic Task Diagnostic 8-63
Logic Task instructions with NOP 10-43
Logic Task Program error 12-54
Low Battery Voltage 12-10
LSF 5-1
M
Mains fault 12-12
Manual input 10-3
Manual vector program is active 12-65
Marker Flags 10-10
MAT 6-43
Max. signal frequency of encoder 1 exceeded 12-7
Max. signal frequency of encoder 2 exceeded 12-10
Measuring Wheel Difference 12-53
Measuring Wheel Mode 8-1, 9-21
Measuring Wheel Mode not possible 12-44
Mechanical Transmission Elements 8-51
MHD 5-1
Motor feedback data memory 5-1
Temperature Monitoring 5-2
MKD 5-1
Automatic Setting of the Motor Type 5-2
Temperature Monitoring 5-2
MKE 5-1
Motor feedback data memory 5-1
Mode unauthorized 12-62
Modulo function 8-52
Modulo range error 12-37
MOM 6-44
Monitoring
Position Loop 8-48
Velocity Control Loop 8-47
Monitoring the Distance Between Home Switch and Reference Mark 8-10
Motor feedback
Saved parameters 5-1
Motor holding brake 5-3
Motor holding brake type 5-4
Motor holding brake connection 5-6
Motor overload 12-23
Motor overtemp. prewarning 12-24
Motor overtemp. shutdown 12-5
Motor temp. surveillance defective 12-6
Motor type Parameter CM00 incorrect 12-33
Motor Types
Motor Characteristics 5-1
Setting of the Motor Type 5-2
Supported Motor Types 5-1
N
NC command illegal 12-57
NC cycle error 12-58
NC cycle time exceeded 12-61
NC instruction number illegal 12-57
NC Variable Number illegal 12-61
Negative travel limit exceeded 12-18
Negative travel limit switch detected 12-19
No curve data 12-55
No incremental measuring system 12-43
No ready signal from supply module 12-15
No serial I/O 12-63