Electric Drives
and Controls
2−1Bosch Rexroth AGBT 6.001070080078 / 03
Overview
2 Overview
This manual contains information on
D the mechanics
D the electrical connection and
D the functions of the control and diagnostic terminal
− BT 6.00 (built-in terminal) and
− BT 6.00 HPG (manual programming terminal).
CAUTION
Danger of malfunctions and damage!
Wrong installation, faulty connection or improper operation can
lead to unexpected or wrong unit reactions and hence to hazard-
ous situations at the welding station.
So please respect the details in the present manual.
The BT 6.00 is a stationary or portable control and diagnostic terminal for
your weld timer and can be used in connection with the PS 5000 and
PS 6000 series of weld timers.
It is intended for
D stationary (e.g. in the control panel of the welding station), for hard-
ware, refer to Section 3.1 from page 3−1), or
D mobile operation (for hardware, refer to Sect. 3.2 from page 3−7).
The BT 6.00 supports the following functions:
D Display and reset of all faults currently active in the timer
D Display and change of important welding and process data.
. The BT 6.00 has been designed for the display and parameter
setting of production-specific data, because access to the com-
plete range of timer functions is not necessary during normal
operation.
If you need to access all available programming and parameter in-
put features of the weld timer, you should use a PC with the ”BOS”
welding software installed.
The operation of the BT 6.00 is described in section 4.
To Next Page
Loading...
