Electric Drives
and Controls
3−3Bosch Rexroth AGBT 6.001070080078 / 03
Assembly and Connection
L Run all connection cables in loops, and use strain reliefs for all cables.
L Fasten the BT 6.00 with the 2 fastening clamps included in the delivery:
1. Insert the terminal into the mounting cutout from the operating side.
2. Engage the fastening clamps in the lateral recesses of the BT 6.00
housing.
3. Tighten the threaded pins at the fastening clamps.
Front panel
Foam rubber
gasket
Mounting surface
(1 to 14 mm thick)
Threaded pin
DIN 914
M 4x35
Fastening clamp
Threaded pin
DIN 914
M 4x35
To Next Page
Loading...
