Electric Drives
and Controls
3−1Bosch Rexroth AGRhoMotion1070072365 / 04
Installation
3 Installation
When installing the Bosch rho4.0, refer to the information on standards
compatibility and operating conditions in sections 2.4 and 2.5.
3.1 Installed positions and clearances
Housing : 19”-housing (horizontal) or drive housing (vertical)
Weight : approx. 3,5 kg
Position : horizontal or vertical
Type : Installation places must at least satisfy the protection
type IP54.
L Plan the following minimum clearances for sufficient ventilation and wi-
ring arrangement:
19”-housing (horizontal): 50 mm left and right
drive housing (vertical): 50 mm above and below
L Install the rho4.0 in such a way that a free access to the connection side
is ensured.
The LED displays should not be covered to be able to check the opera-
tion state at any time.
L Arrange all connection line in loops and use for all lines strain reliefs.
L Keep as large distances as possible to sources of interference.
To Next Page
Loading...
