Bosch rexroth SB24 - Configuring the Control Block; Alignment of the Control Block on the Working Surface

About these products 11/24
RE 66170-10-R/2019-05-15, control block SB24/34, BoschRexrothAG
4.6 Configuring the control block
1. Determine the desired order ofthe block segments (see chapter4.2),
e.g.starting with the connecting plate.
2. Determine the tie rod length (see chapter4.3).
3. Consider the control block segments with pilot oil line X and Rx inthe order
(seechapter4.5).
4. Determine the tie rod nut (see chapter4.4) depending onthe version ofthe final
control block segment (end plate orend valve).
4.7 Alignment ofthe control block onthe working surface
The control block segments can beassembled / disassembled horizontally
orvertically.
▲ Vertical assembly ▲ Horizontal assembly
In case ofhorizontal assembly, the height difference ofthe individual block segments
should becompensated with asuitable underlayer from the fifth control block
segment inorder toensure safe orientation ofthe control block segments toeach
other.
▲ Compensating height differences