Bosch rexroth SB24 - Control Block Disassembly; Preparation of the Disassembly; Disassembly, End Plate; End Valve; Disassembly, Directional Valve Section, and

16/24 Assembly description
BoschRexrothAG, control block SB24/34, RE 66170-10-R/2019-05-15
5.2 Control block disassembly
5.2.1 Preparation ofthe disassembly
▶ Dismount the control block according tothe parameters provided bythe machine
manufacturer and place itonaclean and stable underlayer.
▶ The sealing and flange surfaces must not bedamaged.
▶ The control block segments are tobe numbered individually.
5.2.2 Disassembly, end plate
/ end valve
1. Loosen the nuts and/or byturning them counterclockwise and remove them
from the tie rods
… .
2. Remove the end plate
/ end valve via the tie rods … without jamming.
5.2.3 Disassembly, directional valve section , and
▶ Remove the control block segments , , one after another via the tie
rods
… .