RE 30162-B/04.11 | SYHNC100-SEK...X Bosch Rexroth AG 5/44
About this document
Safety instructions1.3.1
In this documentation, safety instructions are indicated whenever sequences
of operations are explained which bear the risk of personal injury or damage
to property. The measures described for preventing these hazards must be
observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type of risk
Consequences in case of non-compilance
Precausion
f
Warning signs: • Draws attention to the hazard
Signal word: • Identifies the degree of hazard
Type of risk: • Specifies the type or source of the hazard
Consequences: • Describes the consequences of non-compilance
Precautions: • Specifies how the hazard can be prevented
Risk classes according to ANSI Z535.6-2006Table 2:
Warning sign, signal word Meaning
DANGER
indicates a dangerous situation which may cause death
or severe personal injuries if not avoided
WARNING
indicates a dangerous situation which may cause death
or severe personal injuries if not avoided
CAUTION
indicates a dangerous situation which may cause minor
or medium personal injuries if not avoided
NOTE
Damage to property: The product or the environment
could be damaged.
Symbols1.3.2
The following symbols indicate notes which are not safety-relevant but increase
the understanding of the documentation.
Meaning of the symbolsTable 3:
Symbols Meaning
If this information is not observed, the product cannot be used and/
or operated optimally.
abc f
individual, self-dependent step
Denominations1.3.3
The following denominations are used in this documentation:
DenominationsTable 4:
Denomination Meaning
SYHNC100-SEK...3X Digital controller assembly
WIN-PED® Operating software WIN-PED® 6.6 for the SYHNC100-
SEK...3X
RE xxxx Rexroth document in English language
To Next Page
Loading...
