RE 30239-B, Edition 01.2021, Bosch Rexroth AG
Disposal | Digital axis control VT-HMC...1X 31/36
12 Disposal
12.1 ENVIRONMENTAL PROTECTION
Careless disposal of the VT-HMC...1X and the packaging material can lead to
pollution of the environment.
▶ Therefore, dispose of the VT-HMC...1X and the packaging material in
accordance with the currently applicable regulations in your country and
recycle the material.
13 Extension and modification
The control electronics VT-HMC...1X must be neither extended nor converted. If
you convert the VT-HMC...1X, the warranty becomes void.
Only optional accessories may be used, see chapter 7.2 on page 17.
14 Troubleshooting
14.1 HOW TO PROCEED FOR TROUBLESHOOTING
Always work systematically and purposefully, even when under time pressure.
Random and imprudent disassembly and readjustment of settings can, in the
worst-case scenario, result in the inability to determine the original cause of error.
• First obtain a general overview of how your product works in conjunction with
the entire system.
• Try to find out whether the product has functioned properly in conjunction with
the overall system before the fault occurred.
• Try to determine any changes of the overall system in which the product is
integrated:
– Were there any changes to the product’s operating conditions or operating
range?
– Were there any changes (e.g. retrofit) or repairs carried out on the complete
system (machine/system, electrics, control) or on the product?
If yes: What were they?
– Was the product or machine used as intended?
– How did the fault become apparent?
– Try to get a clear idea of the cause of error. If possible, ask the direct
(machine) operator.
• For troubleshooting, use the diagnostic possibilities of IndraWorks.
If you cannot rectify the error, contact one of the contact addresses which can be
found at www.boschrexroth.com or in the address directory in chapter 16.1.
To Next Page
Loading...
