Bosch Rexroth VT-HMC 1X Series - About this documentation; Validity of the documentation; Required and supplementary documentation; Representation of information

RE 30239-B, Edition 01.2021, Bosch Rexroth AG
About this documentation | Digital axis control VT-HMC...1X 5/36
1 About this documentation
1.1 VALIDITY OF THE DOCUMENTATION
This documentation is valid for the digital axis control VT-HMC of series 1X.
This documentation is intended for fitters, operators, service technicians, system
operators and machine manufacturers.
This documentation contains important information on the safe and proper
mounting, transport, commissioning, operation, use, maintenance, demounting
and simple troubleshooting of the product.
▶ Read this documentation thoroughly, especially Chapter 2 “Safety instructions“
and Chapter 3 “General notes on damage to property and damage to the
product“, before working with the digital axis control.
1.2 REQUIRED AND SUPPLEMENTARY DOCUMENTATION
▶ The product must not be commissioned until you have been provided with the
documentation marked with the book symbol
and you have understood and
observed it. The documentations can be found on the product site or at www.
boschrexroth.com/mediadirectory.
Tabelle 1: Required and supplementary documentation
Title Document number Document type
Digital axis control, type VT-HMC...1X RE 30239 Data sheet
Online help in commissioning software IndraWorks Integrated help
Rexroth HydraulicDrive HDS-16, HDx-17 to HDx-20,
Parameters
RE 30330-PA
www.boschrexroth.com/hmc
Parameter description
Rexroth HydraulicDrive, Functions RE 30338-FK
www.boschrexroth.com/hmc
Functional description
Rexroth HydraulicDrive HDS-16, HDx-17 to HDx-20,
Diagnostic Messages
RD 30330-WA
www.boschrexroth.com/hmc
Description of diagnostic
messages
Rexroth HydraulicDrive, Rexroth IndraMotion MLD
(2G)
RE 30336-AP
www.boschrexroth.com/hmc
Application manual
Rexroth HydraulicDrive, Rexroth IndraMotion MLD
(2G), Libraries
RE 30336-RE
www.boschrexroth.com/hmc
Library description
Release Notes RD 30330-RN
www.boschrexroth.com/hmc
Firmware Release Notes
1.3 REPRESENTATION OF INFORMATION
In order that this documentation allows you to work directly and safely with your
product, standardized safety notes, symbols, terms, and abbreviations are used.
For a better understanding, they are explained in the following sections.
1.3.1 Safety instructions
In this documentation, safety instructions precede a sequence of activities
whenever there is a risk of personal injury or damage to equipment. The hazard
avoidance measures described must be observed.
Safety instructions are structured as follows: