In case of non-compliance with this safety instruction, minor or moderate injury
can occur.
In case of non-compliance with this safety instruction, material damage can
occur.
3.3 Symbols used
Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.
3.4 Explaining the signal alert symbol on the device
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
4 Intended Use
Danger of device damage if not the expressly
stated accessories, mounting parts, compo-
nents, cables, lines, software and firmware are
used.
The IndraControl XM21, XM22 control may only be used with the accessories
and mounting parts listed in this documentation. Components that are not ex-
pressly mentioned must neither be attached nor connected. The same applies to
cables and lines.
Only to be operated with the component configurations and combinations ex-
pressly defined and with the software and firmware specified in the correspond-
ing functional description.
IndraControl XM21, XM22 Controls
5/69
Intended Use
R911340667_Edition 04 Bosch Rexroth AG
To Next Page
Loading...
