Bosch SAIC VDI III - Power Supply; LED Status Lights; VCI Manager Launcher; VCI Manager

1 689 989 458 2020-01-01
|
Robert Bosch GmbH
10 | VDI III | Product description Operation | VDI III | 11en
4.7 VCI Manager Launcher
The Windows program "VCI Manager Launcher"
running on the host computer can be used by
the user to select various VCIs in the network.
After VCI selection, further settings can be
made directly in VCI Manager. For this purpo
-
se, VCI Manager Launcher opens VCI Manager
automatically.
4.8 VCI Manager
The "VCI Manager" Windows program running
on the host computer can be used by the user
to configure and update VDI III. Also, "VCI
Manager" is used to configure the connection
between the diagnostic device and the host
computer and to update the firmware of the
diagnostic device.
4.9 System requirements
The "VCI Manager" software is used to set up
and update VDI III. "VCI Manager" is installed
on a computer. VDI III is controlled by way of
the associated user software.
i The system requirements listed below refer
to the use of the "VCI Manager" software.
The user software requirements may differ.
R Windows 7, Windows 8 or Windows 10 (32-
bit and 64-bit)
R 100MB free hard disk space
R 512MB RAM
R 1GHz processor
R 1 free USB port
R 1024x768 display resolution
4.6.2 Power supply
VDI III is designed to be supplied with power
from the vehicle battery by the diagnostic con
-
nection cable. For data transfer or a system
update, VDI III can also be supplied with volt
-
age from the USB port on a computer.
i If VDI III is to be configured for a wireless
connection, power must be supplied by USB
connecting cable.
4.6.3 LED status lights
Four light-emitting diodes (LEDs) are located
on the front of VDI III. The LED indicators pro
-
vide the following status information.
Symbol Color
Status
LED function
Green VDI III without errors
Red
Error occurred, perform a
reset
Green
VDI III connected to vehicle
Flashing
red
Not connected to external 12
or 24V voltage supply
Off VDI III without errors
Red
Error occurred or VDI III in re
-
covery state
Off
VDI III not connected to a
computer
Flashing
green
VDI III connected to computer
Off
VDI III off
Green
VDI III on
Yellow/
green
Depending on user software
Yellow/
green
Depending on user software