1 689 989 458 2020-01-01
|
Robert Bosch GmbH
4 | VDI III | Symbols used | VDI III | 5en
en – Contents English
1. Symbols used 5
1.1 In the documentation 5
1.1.1 Warnings – structure and explanation 5
1.1.2 Symbols – designation and explanation 5
1.2 On the product 5
2. User instructions 6
2.1 User group 6
2.2 FCC compliance (USA) 6
2.3 Open-source software (OSS) 6
2.4 Electromagnetic compatibility (EMC) 6
2.5 Range of application 6
2.6 Wireless link (Bluetooth and WLAN) 6
2.7 Other applicable documents 8
3. Safety instructions 8
4. Product description 8
4.1 Intended use 8
4.2 Scope of delivery 8
4.3 VDI III ports and control elements 9
4.4 Universal serial bus (USB) port 9
4.5 Wireless local area network (WLAN) 9
4.6 Other properties of VDI III 9
4.6.1 Data transfer 9
4.6.2 Power supply 10
4.6.3 LED status lights 10
4.7 VCI Manager Launcher 10
4.8 VCI Manager 10
4.9 System requirements 10
5. Operation 11
5.1 Notes on installation 11
5.2 Software installation 11
5.3 Setting up the diagnostic-device hardware 11
5.3.1 Connecting the diagnostic device 11
5.3.2 Updating the diagnostic-device software 11
5.3.3 Configuring VDI III using VCI Manager 12
5.3.4 Checking the computer and VDI III software
versions 12
5.4 WLAN connection setup 13
5.4.1 Activating the WLAN connection via
an access point 13
5.4.2 Enabling a direct point-to-point wireless
connection 14
5.4.3 Reset to factory settings 15
5.5 Connecting the diagnostic device to
a vehicle 15
5.6 Resetting VDI III 16
5.7 Loopback self-test 16
6. Troubleshooting 17
6.1 VDI III error LED lights after power on 17
6.2 VDI III does not switch on 17
6.3 "Vehicle" LED flashes red 17
6.4 VDI III speaker beeps 17
6.5 VDI III switches off immediately when
disconnected from the vehicle during a
diagnostic session 18
6.6 "Checkmark" LED on VDI III flashes 18
6.7 Suspected defective diagnostic connection
cable 18
6.8 Wireless communication with network by
DWA131E1 dongle unsuccessful 19
6.9 VCI Manager displays a yellow icon on
VDI III after use of the device 19
6.10 Computer application is unable to
communicate with VDI III by USB 19
6.11 Computer application is unable to
communicate with VDI III by WLAN
or Ethernet 20
7. Cleaning and maintenance 20
7.1 Restoring the VDI III system software
(recovery) 20
7.2 Spare and wearing parts 20
8. Decommissioning 21
8.1 Temporary shutdown 21
8.2 Changing location 21
8.3 Disposal 21
9. Glossary 21
10. Technical data 22
To Next Page
Loading...
