Bosch SDS-clic - Page 10

10 | English
u Use the quick-clamping nut1603340031 only for bonded
grinding and cutting discs and for diamond cutting discs on
an angle grinder with an M14 grinding spindle thread – see
figureA2.
u Use the quick-clamping nut2608000638 for bonded
grinding and cutting discs and for diamond cutting discs,
as well as for carbide grinding heads only on a(n)Bosch
angle grinder with magnetic braking function and an
M14x1.5 grinding spindle thread – see figureA2.
u Only use quick-clamping nuts(3) that are in good working
order and not damaged.
Clean the grinding spindle(5), the mounting flange(4) and the
quick-clamping nut(3).
When screwing on, make sure that the printed side of the quick-
clamping nut(3) is not facing the grinding wheel; the arrow(1)
must be pointing towards the index mark(2) – see figureA1.
If the quick-clamping nut(3) is tightened without the arrow(1)
being within the index mark(2), the quick-clamping nut(3) can
1 609 92A 94P | (22.02.2024) Bosch Power Tools