17
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start/Resume] until the display indicates
“H:0x” (x can be any number).
3 Release both buttons.
4 Press the “A” button until the display indicates “P:0x”.
5 Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
6 Press [Start/Resume] to save the setting.
InfoLight®
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start/Resume] until the display indicates
“H:0x”.
(x can be any number)
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the “C” button to switch between “1:01” = ON and “1:00” = OFF and press [Start/Resume]
to save.
Aquastop® Leak Protection
Our AquaStop® system contains leaks through a precisely engineered tub and sensor system that works
with our solid molded base. If a leak has occurred, it shuts down operation and automatically pumps
out water to avoid contact with the floor. It works 24/7 and can turn itself on.
To Next Page
Loading...
