en-us Operating the Dishwasher
26
Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
To set Delay start:
1.
Press On/Off button (. Select a
cycle.
2.
Press Delay button ` until the
displayed time corresponds with
your requirements.
3.
Press Start button h to activate
Delay start.
To cancel Delay start:
1.
Press Delay button ` until œ:‹‹
is indicated on the digital
display H.
2.
Press Start button h to save
setting.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button h again.
Wash cycle end
The wash cycle has ended when the
display H reads ‹:‹‹.
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
To change the setting:
1.
Press the On/Off button (.
2.
Hold down the selection button
> X and press the Start button
h until the display H
indicates š:‹x (x can be any
number).
3.
Release both buttons.
4.
Press the selection button >
Xuntil the display H indicates
˜:‹x.
5.
Press the selection button < 8
until the display corresponds with
your requirements.
6.
Press the Start button h.
œ:‹‚ 1 hour delay
œ:ƒ… 24 hours delay
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To Next Page
Loading...
