Bosch SHE68T55UC - Operating the Dishwasher; Auto Power Off and Switching Off; Interrupting and Terminating Wash Cycles

Operating the Dishwasher en-us
33
Auto power off
To save energy, the dishwasher is
turned off 1 minute after the wash
cycle ends.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
To change the setting:
1. Press the On/Off button (.
2. Hold down the function key #
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
3. Release both buttons.
4. Press the function key # until
the display 8 indicates ˜:‹x.
5. Press the function key 3 until
the display corresponds with your
requirements.
6. Press the Start button P.
Switching off the appliance
Short time after the end of the wash
cycle:
1. Press On/Off button (.
2. Turn off water supply.
3. Remove the utensils when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1. Press On/Off button (.
The LED’s go out. The wash cycle
is saved.
2. To continue the wash cycle, close
the door and press On/Off button
( again.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
Terminating the wash cycle
(Reset)
Terminating the wash cycle 1. Press and hold Start button P
for approximately 3 seconds until
the display reads ‹:‹‚.
2. Wait about 1 minute while the
dishwasher drains.
3. Press On/Off button (.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)