702_58300000170749_ara_en_c Page 56 of 82
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary
information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
5.13 Water switch
The water switch is best accessed from the bottom of the
dishwasher by flipping it on it’s back. Use the same process to
access the heat pump and the sump.
Tools needed: T20 Torx, #2 Phillips & small flat blade
screwdrivers and pliers.
1. Flip dishwasher for bottom access – section 5.1.6.1.
2. To remove water switch motor assembly, remove three (3)
screws and lift it from the sump (below).
3. To gain access to remove water switch housing / disk,
remove heat pump – section 5.12.
4. Use a small flat blade screwdriver to unlatch water switch
housing from sump, rotate housing counter-clockwise and
lift it out from the sump to remove it (below).
5. This is what the parts look like when removed.
2. Drain pump
3. Heat pump
4. Clamp
5. Adapter
6. Seal ring
To Next Page
Loading...
