13
Care and Maintenance (continued)
Figure 23
4. Carefully examine the assembly. If you find
debris in the Large Object Trap, turn it
upside-down and gently tap it on a surface
such as a countertop to dislodge and remove
the debris. Flush the Cylinder Filter clean by
holding it under running water.
Large
Object
Trap/
Cylinder
Filter
To avoid injury, do not reach into the large
object trap with your fingers. The large
object trap could contain sharp objects.
CAUTION
3. Lift out the assembly as shown in
Figure 23.
Clean the Exterior Door Panel
To avoid possible diswasher damage, do
not use harsh chemicals, abrasive
cleaners, scouring pads (metal or plastic),
or abrasive cloths/paper towels to clean
your dishwasher’s exterior door panel.
Your dishwasher’s exterior door panel can
be damaged by doing so.
Colored Doors
Use only a soft cloth that is lightly dampened with
soapy water.
Stainless Steel Doors
Use a soft cloth with a non-abrasive cleaner
(preferably a liquid spray) made for cleaning
stainless steel. For the best results, apply the
stainless steel cleaner to the cloth, then wipe the
surface.
Clean the Door Gasket
Regularly clean the door gasket with a damp
cloth to remove food particles and other debris.
To reinstall the filter system:
1. Return the Fine Filter to its installed position.
2. Place the Large Object Trap/Cylinder Filter
Assembly into its installed position in the
dishwasher floor.
3. Turn the ring handle clockwise 1/4 turn until it
is locked.
The arrow
on the ring
handle
and the
arrow on
the Fine
Filter
should
point to
each
other, as
shown by the circle in Figure 25.
4. Gently pull the ring handle to ensure that the
assembly is locked into place.
To Remove the Fine Filter:
1. Lift the Fine Filter from the dishwasher floor
as shown
in Figure
24 and
flush it
clean by
holding it
under
running
water.
Figure 24
Figure 25
Fine
Filter
To Next Page
Loading...
Need help?
General
