EasyManua.ls Logo

Bosch SHX68T52UC/07 - Page 20

Bosch SHX68T52UC/07
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1 Press the [On/Off] button.
2 Hold down the A” button and press [Start] until the display indi-
cates “d:00”. Release both buttons
3 Press the “A” button until the display shows “d:00”.
4 Press the C” button to turn intensive drying on or off. “d:01” = ON
and “d:00” = OFF and press [Start] to save setting.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. This setting can be adjusted from P:00 to P:02.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates “d:0x” (x can be any number). Release both buttons.
3 Press the “A” button until the display indicates “P:0x”.
4 Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5 Press [Start] to save the setting.
InfoLight® (model dependent)
An LED illuminates the floor to indicate the unit is running. If the appliance is
installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the A” button and press [Start] until the display indicates
d:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the C” button to switch between “1:01” = ON and “1:00” = OFF
and press [Start] to save.
Child Lock (model dependent)
1 Start the desired cycle.
2 Hold down the button that says “Child Lock” underneath it for approxi-
mately 3 seconds until the display reads “CL”.
3 The “CL” will be indicated now if any button is pressed and the pro-gram
will not be reset.
To deactivate the child lock, hold down the “Child Lock” button for approxi-
mately 3 seconds until the display no longer reads “CL”.

Related product manuals