8
START YOUR DISHWASHER
1. Press the On/O button.
2. Select a cycle and option if desired.
3. Press Start.
ADJUSTING THE SETTINGS
1. Press the On/O button. Hold down button A (see pages 6-7) and
press Start until the display shows H:0x or d:0x.
2. Release both buttons. The LED for the function key ashes and the
digital display shows the factory set value. Press A to choose the
setting.
3. Press buttons B or C (up or down) to change the setting.
4. Press Start button to save the setting.
Setting Factory setting Description
H-water hardness
H:00-H:07
H:04 Setting the water
hardness
r-Rinse Aid
r:00-r:06
r:05 Amount of rinse aid
aects drying
d-Intensive drying
d:00-d:01
d:00/ o Improved drying for
glasses and plastic
b-Beep at cycle end
b:00-b:03
b:02 Sound level when cycle
is complete
I-Info light
I:00-I:01
I:01 / on Light projected to signal
active wash cycle
P-Auto power o
P:00-P:02
P:01 / o after one
minute
Unit switches o after
cycle is complete, either
after 1 minute or 2 hours.
ADD RINSE AID
This dishwasher is designed to be used
with rinse aid, which enhances drying
results and shine.
• Add rinse aid before rst use and when
the Add Rinse Aid indicator light on the
control panel illuminates.
• Lift tab to open the rinse aid reservoir
and add liquid rinse aid into the oval
until it is full, avoiding air vent. Wipe up
any excess rinse aid that may puddle.
Tip: Remove lid of rinse aid bottle for easier pouring.
To Next Page
Loading...
Need help?
General
