Operating the Dishwasher en-us
41
Wash cycle end
The wash cycle has ended when
“Finished” is indicated on the digital
display @ and ):.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press On/Off button (.
2.
Turn off water supply.
3.
Remove the utensils when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch (.
The LED’s go out. The wash cycle
is saved.
3.
To continue the wash cycle,
switch on the On/Off switch (
again.
4.
Close the door.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Cancel a cycle (reset)
1.
Open the door and press and
hold the Start button )" for
approximately 3 seconds until the
digital display @ shows:
"Program was terminated".
2.
Close the door.
3.
Wait about 1 minute while the
dishwasher drains.
4.
Open the door and press the
On/Off switch (.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
To Next Page
Loading...
