en-us Rinse Aid
16
Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from §:‹‹ to §:‹‡. The
factory setting is §:‹†.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
1.
Press the On/Off button (.
2.
Hold down the function key #
and press the Start button P
until the display 8 indicates
•:‹x or š:‹x (x can be any
number). Release both buttons.
3.
Press the function key # until
the display 8 shows §:‹†.
4.
Press the function key 3 to
select the desired setting.
5.
Press the Start button P to
save the setting.
Turning off rinse aid
indicator
Proceed as described in the section
“Setting the amount of rinse aid
used” and set value to §:‹‹. The
rinse aid indicator is now turned off.
NOTICE
Using no rinse aid or setting the
dispenser to §:‹‹ may result in
longer cycle times consuming more
energy and water. The higher
temperatures and longer cycle times
can damage fine china or glassware.
Setting Amount
§:‹‹ dispenser is OFF
§:‹‚ lowest setting
§:‹ƒ low setting
§:‹„ medium setting
§:‹… medium/high setting
§:‹† high setting
§:‹‡ highest setting
To Next Page
Loading...
Need help?
General
