Care and Maintenance en-us
39
Drain pump
Large food remnants in the rinsing
water not retained by the filters may
block the waste water pump. In this
case:
■ Disconnect the appliance from the
power supply.
■ Remove the filters. ~ "Filters"
on page 37
■ Scoop out standing water - use a
sponge if necessary.
■ Using a spoon, pry off the pump
cover until it clicks, then grip the
cover and pull upward until it
resists and then pull forward.
■ Check inner compartment and
remove any foreign objects.
9 WARNING
Use caution when removing
parts for cleaning as some
debris may be sharp.
■ Place cover in the original
position, press down and engage.
■ Reinstall filters.
Note: The drain pump will not work
properly if the drain pump cover is
not snapped in completely until it
clicks.
&OLFN
To Next Page
Loading...
Need help?
General
