Troubleshooting aus
45
Fault Cause Troubleshooting
Detergent residue in the ap-
pliance
Tabs are used in the quick
or short programme. Dissolv-
ing time of the tab is not at-
tained.
▶
Select a more intensive Programme
or use Powder detergent.
Washing effect and dissolv-
ing performance are re-
duced after a prolonged
storage time or detergent is
very lumpy.
▶
Change your "detergent"
→Page26.
Water marks on plastic
parts.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
▶
Select a more intensive pro-
gramme.
▶
Position tableware at an angle.
→"Arrange tableware", Page29
▶
Use rinse aid.
→"Rinse aid", Page25
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
→Page26.
▶
Clean the appliance mechanically.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
→Page26.
▶
Clean the appliance mechanically.
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change "Detergent "
→Page26.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
Tea residue or lipstick marks
on tableware.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
Too little detergent is being
used or is unsuitable.
▶
Use a suitable "Detergent "
→Page26 and follow the manufac-
turer's instructions for the amount
to be used.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
To Next Page
Loading...
