Bosch Solution 16i - Page 107

9-17
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
Comms > IP > L560
Base Station IP Address

MENU 5-6-0
Dest Nº 1
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
Dest Nº 2
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
i
Note
This feature requires rmware version 2.10 or higher.
This menu allows the installer to program the TCP IP
address for Destination 1 and/or Destination 2 so that
the control panel can communicate to the base station
receiver.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [6] + [0] + [OK]. The keypad will prompt
you to enter which destination (destination 1 or 2)
that you want to program the base staion IP
addrress.
dst=
3) Enter the destination number (1 or 2) required,
then press [OK]to select.
4) The keypad will display the rst six digits of the
base station IP address.
000000
5) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the new MyAlarm IP Address, then
press [OK] to save and exit or press [MENU] to exit
without saving.
Comms > IP > L561
Base Station Port Number

MENU 5-6-1
IP
Dest Nº 1
0 7 7 0 0
IP
Dest Nº 1
0 7 7 0 0
i
Note
This feature requires rmware version 2.10 or higher.
This menu allows the installer to program the TCP IP port
number for Destination 1 and/or Destination 2 so that
the control panel can communicate to the base station
receiver. The port number must be 5 digits long within
the range - to 65535.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [6] + [1] + [OK]. The keypad will prompt
you to enter which destination (destination 1 or 2)
that you want to program the base staion port
number.
dst=
3) Enter the destination number (1 or 2) required,
then press [OK]to select.
4) The keypad will display the current base station
port number.
07700
5) Use the numeric keys [0] to [9] to program the new
MyAlarm IP Address, then press [OK] to save and
exit or press [MENU] to exit without saving.
Comms > IP > L562
Poll Rate

MENU 5-6-2
0 0 6 0
SECONDS
i
Note
This feature requires rmware version 2.10 or higher
This menu allows the installer to program how often the
control panel sends a signal to the base station receiver
via Destination 1 and/or Destination 2. The poll interval
programmed should be set so that the control panel sends
a poll to the base station receiver at least once within the
polling time required.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [6] + [2] + [OK]. The keypad will prompt
you to enter which destination (destination 1 or 2)
that you want to program the poll rate.
dst=
3) Enter the destination number (1 or 2) required,
then press [OK]to select.
4) The keypad will display the current poll rate.