Bosch Solution 16i - Page 108

9-18
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
0060
5) Use the numeric keys [0] to [9] to program the new
poll rate in seconds (0000 to 1300), then press [OK]
to save and exit or press [MENU] to exit without
saving.
Comms > IP > L563
Acknowledge Wait Time

MENU 5-6-3
0 1 0
SECONDS
i
Note
This feature requires rmware version 2.10 or higher
This menu allows the installer to program the
acknowledge wait time in seconds for both Destination 1
and/or Destination 2. The acknowledge wait time can be
programmed between 1 and 255 seconds (0 = Disabled).
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [6] + [3] + [OK]. The keypad will prompt
you to enter which destination (destination 1 or 2)
that you want to program the acknowledge wait
time.
dst=
3) Enter the destination number (1 or 2) required,
then press [OK]to select.
4) The keypad will display the current acknowledge
wait time.
d= 010
5) Use the numeric keys [0] to [9] to program the new
acknowledge wait time in seconds (000 to 255),
then press [OK] to save and exit or press [MENU] to
exit without saving.
Comms > IP > L564
IP Format

MENU 5-6-4
0 = Conettix 0 1
1 = Conettix NNC (Anti Replay)
2 = CSV IP ALARM
i
Note
This feature requires rmware version 2.10 or higher.
This menu allows the installer to program which IP format
the control panel will report to the base station receiver.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [6] + [4] + [OK]. The keypad will prompt
you to enter which destination (destination 1 or 2)
that you want to program the acknowledge wait
time.
dst=
3) Enter the destination number (1 or 2) required,
then press [OK]to select.
4) The keypad will display the current IP format.
d= 00
5) Use the numeric keys [0] to [9] to program the new
IP format required, then press [OK] to save and exit
or press [MENU] to exit without saving.
i
Note
dSt= Enter Destination 1 or Destination 2 then
press [OK].
Comms > IP > L565
Retry Count

MENU 5-6-5
0 3
i
Note
This feature requires rmware version 2.10 or higher.
This menu allows the installer to program the number of
attempts that the system will try to communicate via TCP/
IP to the base station receiver for both Destination 1 and/
or Destination 2. The retry count can be programmed
between 1 and 15 (0=Disabled).
1) Enter your Installer PIN + [MENU].