Bosch Solution 16i - Page 109

9-19
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
2) Enter [5] + [6] + [5] + [OK]. The keypad will prompt
you to enter which destination (destination 1 or 2)
that you want to program the acknowledge wait
time.
dst=
3) Enter the destination number (1 or 2) required,
then press [OK]to select.
4) The keypad will display the current acknowledge
wait time.
d= 03
5) Use the numeric keys [0] to [9] to program the new
retry count, then press [OK] to save and exit or
press [MENU] to exit without saving.
i
Note
dSt= Enter Destination 1 or Destination 2 then
press [OK].
Comms > IP > L566
RAS IP Address

-

MENU 5-6-6
inst?
Installer?
IP 1
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
user?
User?
IP 2
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
i
Note
This feature requires rmware version 2.10 or higher.
This menu allows the installer or Master user the ability to
program the Solution Link IP address.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [5] + [6] + [6] + [OK]. The keypad will prompt
you to enter which Solution Link IP address (IP 1 =
Installer or IP 2 = User) that you want to program.
inst?
The installer can now select either the installer
Solution Link IP address or the user Solution Link IP
address by using the up and down arrow keys. If the
Master user programs this menu, the keyapd will only
display the option to program the user IP address:
user?
3) Select the which IP address that you want to
change (installer or user, then press [OK] to enter.
4) The keypad will display the rst six digits of the
Solution Link IP address.
000000
5) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the IP Address, then press [OK] to save
and exit or press [MENU] to exit without saving.
Comms > IP > L567
RAS IP Port

-

MENU 5-6-7
inst?
Installer?
IP 1
0 7 7 0 1
user?
User?
IP 2
0 7 7 0 1
i
Note
This feature requires rmware version 2.10 or higher.
This menu allows the installer or Master user the ability to
program the Solution Link IP port number. The Solution
Link IP port number must be 5 digits in length and
programmed within the range of 0 to 65535.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [5] + [6] + [6] + [OK]. The keypad will prompt
you to enter which Solution Link IP port number (IP
1 = Installer or IP 2 = User) that you want to
program..
inst?
The installer can now select either the installer
Solution Link IP port number or the user Solution Link
IP port number by using the up and down arrow keys.
If the Master user programs this menu, the keyapd will
only display the option to program the user IP port
number:
user?
3) Select the which IP port number that you want to
change (installer or user, then press [OK] to enter.