Bosch Solution 16i - Page 120

10-8
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Device Programming
Devices > RF Devices > L623
Add RF Keypad

MENU 6-2-3
Reserved for future use.
Devices > RF Devices > L624
Delete RF Keypad

MENU 6-2-4
Reserved for future use.
Devices > RF Devices > L625
View RF Device ID

MENU 6-2-5
This command allows you to trap and view a transmitters
I.D. number when it has been forgotten or it is no longer
legible on the transmitter label. The device being tested
must be compatible with the RF receiver tted to the
panel.
1) Enter your Installer PIN + [MENU].
2) Enter [6] + [2] + [5] + [OK]. The system will then
begin waiting for a valid trigger signal.
triger
3) Trigger the transmitter by pressing any button on
the keyfob or by triggering the tamper switch on
any sensor. The keypad will display the rst 6 digits
of the serial number of the RF device.
098765
Use the left and right arrow keys to scroll through the
RF serial number.
To test another transmitter, repeat step 3.
4) Press [OK] or [MENU] to exit this command.
S ER IA L DE VI C E O PT I ON S
Devices > Serial Device > L630
Device Type

MENU 6-3-0
00 = Disabled 0 0
01 = Serial Printer
02 = Computer
Reserved for future use.
Devices > Serial Device > L631
Baud Rate

MENU 6-3-1
00 = No Device Connected 0 0
01 = 300 Baud 05 = 9600 Baud
02 = 600 Baud 06 = 19200 Baud
03 = 1200 Baud
04 = 2400 Baud
Reserved for future use.
Devices > Serial Device > L632
Flow Control

MENU 6-3-2
00 = No Handshaking 0 0
01 = Hardware
02 = Xon-Xo
Reserved for future use.
Devices > GSM Modem > L650
Report Format

MENU 6-5-0
00 = SIA 0 0
01 = CID
02 = Domestic
Reserved for future use
Devices > GSM Modem > L651
Options

MENU 6-5-1
00 = Reserved 0 0
01 = Reserved
02 = Reserved
Reserved for future use.