11-11
Bosch Security Systems 09/11 BLCC500I
Solution 16i
Installation Manual System Programming
your system with your installer.
The following prompts will be shown when entering the
schedule time parameters.
Shh = Start Time Hours
Smm = Start Time Minutes
Ehh = End Time Hours
Emm = End Time Minutes
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [5] + [1] + [OK].
The keypad will display the sh = prompt.
Sh=
3) Enter the Schedule number you want to program,
then press [OK].
Shh=00
4) Enter the hour (00 - 23) of the day that the schedule
will start.
SMM=00
5) Enter the minutes (00 - 59) of the hour that the
schedule will start.
Ehh=00
6) Enter the hour (00 - 23) of the day that the schedule
will end.
emm=00
7) Enter the minutes (00 - 59) of the hour that the
schedule will end.
8) Use the [←] and [→] keys to conrm programming
and then press [OK] to exit.
System > Schedules > Sh DAy
Day
-
MENU 7-5-2
Sun Mon Tue Wed Thu Fri Sat Hol
Y Y Y Y Y Y Y N
This menu you to program which days of the week the
schedule will operate.
1 = Sunday 5 = Thursday
2 = Monday 6 = Friday
3 = Tuesday 7 = Saturday
4 = Wednesday 8 = Holidays
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [7] + [5] + [2] + [OK].
The keypad will display the sh = prompt.
Sh=
3) Enter the Schedule number (1-8) you want to
program, then press [OK].
-Bit-
2 3 4 6 7
4) Using keys [1] to [8], toggle on or o which days of
the week the schedule will operate.
Repeat Step 4 until all required days for the schedule
are programmed.
5) Press [OK] to save and exit, or press [MENU] to exit
without saving.
System > Schedules > l753
Function
MENU 7-5-3
00 = Disabled 0 0
01 = Area On/O 03 = Operate Output
02 = Area Part On/O 04 = Timer Group
This menu allows you to program what function the
schedule will perform. There are a number of options
which are explained in more detail below. Only one option
can be programmed.
1) Enter your Installer PIN + [MENU].
2) Enter [7] + [5] + [3] + [OK].
The keypad will display the sh = prompt.
To Next Page
Loading...
