Bosch Solution 16i - Page 51

5-9
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Access Programming
Access > Global Properties > L151
PIN Retry Count

MENU 1-5-1
(*** System Wide Parameter ***)
6
This menu sets how many times an invalid PIN can be
entered before the keypad will be quarantined or locked out.
See MENU 6-1-8 — Keypad Lockout Time to set the lockout
time period.
An Access Denied report will be sent to the base station
when the keypad is quanrantined. If keypad lockout is not
required set this option to 0.
The PIN retry count is reset every time the corresponding
area is turned All On, Part On or O.
1) Enter your Intstaller PIN + [MENU].
2) Enter [1] + [5] + [1] + [OK]. The keypad will display
the current PIN retry count.
d= 06
3) Enter the required PIN Retry Count using the up
and down arrow keys then press [OK] to save and
exit or press [MENU] to exit without saving. Valid
entries are 1 - 15 , 0 = Unlimited.
Access > Global Properties > L152
Installer PIN

MENU 1-5-2
(*** System Wide Parameter ***)
1 2 3 4
This menu sets the Installer PIN. The Installer can access all
menu functions and can also disarm one or multiple areas.
The Installer PIN Can Be Up To 8 Digits Long.
The factory default Installer PIN is 1234.
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [5] + [2] + [OK]. The keypad will display
the current Installer PIN.
1234AA
3) Enter the required PIN Retry Count using the up
and down arrow keys then press [OK] to save and
exit or press [MENU] to exit without saving.
Access > Global Properties > L153
PIN Expire Time

MENU 1-5-3
0 3 0
(*** System Wide Parameter ***)
DAYS
This menu programs how many days PINs that have been
programmed to expire, will be able to operate the system.
Every time a valid temporary code is used, the Expire Time
counter will restart.
To renew a temporary user, the Installer or Master user
must reprogram the PIN. The PIN Expire Time is global for
all temporary PIN users.
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [5] + [3] + [OK]. The keypad will display
the current PIN Expire Time.
d= 030
3) Enter the new PIN Expire Time using the numeric
keys. Valid entries are 0 - 255 days.
4) Press [OK] to save and exit or press [MENU] to exit
without saving. cursor position to the end of the
line.
P ROX RE AD E RS
Access > Prox Reader > L160
Name

MENU 1-6-0
R e a d e r 1 N a m e
This menu allows the installer to program the name or
location description of the prox reader. Up to 8 dierent
Readers can be used on the Solution 16i via keypads that
have built-in Readers.
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [6] + [0] + [OK] and enter the Reader
number required, then press [OK].
rEAdEr
3) Use the arrow and number keys to move and
change text. When the Reader Name is complete,
press [OK]. At any time you can press the [OFF] key
to clear the text from the current cursor position to
the end of the line.
i
Note
See Alpha Text Programming in Section 4 -
Programming Overview for further detail on entering
alpha text.