Solution 6000-IP
Installation Manual Device Programming
10-15
Bosch Security Systems 10/22 BLCC615I
Devices > GSM/GPRS Module >
APN Password
MENU 6-5-9
A secret word or phrase that must be used to gain
admission to the network however mostly left BLANK.
1) Press [MENU] + [6] + [5] + [9] and use the up and
down arrows to highlight the GSM/GPRS module in
the list then press [OK].
2) Use the arrow and number keys to move and
change text. When the APN password is complete,
press [OK]. At any time you can press the [OFF] key
to clear the text from the current cursor position to
the end of the line.
APN Password Gi1
Press OK to SAVE
See Alpha Text Programming in Section 4 —
Programming Overview for further detail on entering
alpha text.
Devices > Ethernet Module >
Module IP Address
MENU 6-6-0
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
This is the IP address of the TCP/IP module on the
customer’s internal local area network.
1) Press [MENU] + [6] + [6] + [0]. The keypad will
display the current IP address.
Module IP Address
000000000000
Press 0-9 OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the IP Address, then press [OK] to save
and exit or press [MENU] to exit without saving.
Devices > Ethernet Module >
Subnet Mask
MENU 6-6-1
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
The can be found by running IPCONFIG on a PC
connected to the clients network. Typical subnet mask is
255.255.255.0.
1) Press [MENU] + [6] + [6] + [1]. The keypad will
display the current subnet mask.
Subnet Mask
000000000000
Press 0-9 OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 12 digit subnet mask number, then
press [OK] to save and exit or press [MENU] to exit
without saving.
Devices > Ethernet Module >
Default Gateway
MENU 6-6-2
1 Digits 12
0 0 0 0 0 0 0 0 0 0 0 0
The can be found by running IPCONFIG on a PC connected
to the clients network.
1) Press [MENU] + [6] + [6] + [2]. The keypad will
display the current gateway number.
Default Gateway
000000000000
Press 0-9 OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 12 digit gateway number, then
press [OK] to save and exit or press [MENU] to exit
without saving.
Devices > Ethernet Module >
Module MAC Address
MENU 6-6-3
0 0 0 0 0 0 0 0 0 0 0 0
This is the hardware machine address of the module and
can be found on the bar-coded sticker.
1) Press [MENU] + [6] + [6] + [3]. The keypad will
display the current MAC address.
Module MAC Address
000000000000
Press OK to SAVE
2) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the MAC address, then press [OK] to
save and exit or press [MENU] to exit without
saving. This is the hardware machine address of the
module and can be found on the bar-coded sticker.
To Next Page
Loading...
