Bosch Solution 6000-IP - Page 140

Solution 6000-IP  Installation Manual  System Programming
11-10
Bosch Security Systems 10/22 BLCC615I
System > Siren >
Speed

MENU 7-4-1
This menu allows you to customise the speed of the siren
tone when a non-fire alarm is triggered. By changing the
tone and speed, it is possible to program a unique siren
sound for each system when you are installing a number
of them in close proximity to each other.
1) Press [MENU] + [7] + [4] + [1]. The keypad will
display the current siren speed.
Speed
S. . . . . . . . . . . . . F
-------------

---------
Press  OK to SAVE
2) Use the up and down arrow keys to change the
siren speed.
3) To test the new siren speed press [ON] to sound the
siren and press [OFF] to turn the siren off.
4) Repeat Steps 2 and 3 until the desired siren tone is
achieved then press [OK] to save and exit, or press
[MENU] to exit without saving.
i
Note
Only outputs programmed as event type 36 and or
37 will be affected by this menu option.
System > Siren >
Volume

-

MENU 7-4-2
(*** System Wide Parameter ***)
1 5
This menu allows you to program the volume level of the
radio key speeker beeps which are heard when the system
is armed and disarmed using a radio keyfob.
1) Press [MENU] + [7] + [4] + [2]. The keypad will
display the current siren volume (default = 15).
Volume
15
Press 0-9 OK to SAVE
2) Using the numeric keys, enter the new volume
level. Valid entries are 0 to 15 where 15 = the
loudest volume and 0 = no speeker beeps.
3) Press [OK] to save and exit or press [MENU] to exit
without saving.
i
Note
Only outputs programmed as Event Type 36, horn
speaker with beeps will be effected by this menu
option.
System > Siren >
Siren Swinger

MENU 7-4-3
(*** System Wide Parameter ***)
0
3
This menu allows you to program how many times a zone
programmed for Lockout Siren can sound the siren during
each arming cycle.
At default, zones programmed for Lockout Siren will be
able to trigger the siren 3 times before being locked out.
The count will be reset when the system or area is next
disarmed.
1) Press [MENU] + [7] + [4] + [3]. The keypad will
display the current Swinger Siren count.
Siren Swinger
3
Press 0-9 OK to SAVE
2) Using the numeric keys, enter the new swinger
siren count. Valid entries are 0 to 15 where 0 =
unlimited.
3) Press [OK] to save and exit or press [MENU] to exit
without saving.