EasyManua.ls Logo

Bosch TCA53 Series - Steaming Milk for Coffee Drinks; Milk Foaming Process; Cleaning After Steaming Milk; Recommended Milk Type for Foaming

Bosch TCA53 Series
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
TCA53 03/2012
en
Steamforfoamingmilk
Theappliancemustbereadyforuse.You
canfoamthemilkrstandaddthecoffee
ontop,orfoamthemilkseparatelyand
pouritintothecoffee.
¡
Riskofburns
Thenozzlegetsveryhot.Donottouchthe
metalparts.
Pushthesleeveonthenozzle8allthe
waydown.
Fillthecupapproximately1/3fullofmilk.
Pressthesteambuttonh.TheLEDwill
starttoash.
iTheappliancewillheatupforapprox.
20seconds.
Immersethenozzle8deepintothemilk,
butdonotletittouchthebottomofthe
cup.
AssoonastheLEDJlightsup,turnthe
rotarybutton6tog/h.
¡
Riskofscalding
Whenthedial6issettog/h,thenozzle
8maysputter.Escapingsteamisveryhot
andmaycauseliquidstosputter.Donot
touchthenozzle8orpointitatanyone.
Rotatethecupslowlyuntilthemilkisfully
foamed.
Endtheprocessbyturningthedial6
backto“O”.
iTofoammoremilk,pressthesteam
buttonhagainandrepeatthewhole
process.
Note:Whenthenozzle8hascooleddown,
cleanimmediately.Driedresidueisdifcult
toremove.
Tip:Ifpossible,usecoldlowfat(1,5%fat)
milk.
Steamforheatingdrinks
¡
Riskofburns
Thenozzlegetsveryhot.Donottouchthe
metalparts.
Theappliancemustbereadyforuse.
Pushthesleeveonthenozzle8allthe
wayup.
Pressthesteambuttonh.TheLEDwill
starttoash.
iTheappliancewillnowheatupfor
approx.20seconds.
Immersethenozzle8deepintotheliquid
youwanttoheat.
AssoonastheLEDJlightsup,turnthe
rotarybutton6tog/h.
¡
Riskofscalding
Whenthedial6issettog/h,thenozzle
8maysputteralittle.Escapingsteamis
veryhotandmaycauseliquidtosputter.Do
nottouchthenozzle8orpointitatanyone.
Endtheprocessbyturningthedial6
backto“O”.
iTogeneratemoresteam,pressthesteam
buttonhagainandrepeatthewhole
process.
Note:Whenthenozzle8hascooleddown,
cleanimmediately.Driedresidueisdifcult
toremove.

Related product manuals