Bosch TCA53 Series - Large Coffee Dispensing and Steam Controls; Interpreting LED Display Indicators; Settings and Display Information; Setting Water Hardness Levels

14
RobertBoschHausgeräteGmbH
en
4Dispensingbutton
FLargecoffee
Withthisbutton,alargecup
(approx.125ml)ofcoffeecanbedispensed.
● Pressthebutton4F.TheLEDwillstart
toash.Thecoffeeisground,brewed
andpouredintothecup.BothLEDslight
upassoonastheprocessisnished.
Thebeveragesizecanbechanged(see
section“Changingvolumedispensed”)
5Steamgenerationbuttonh
Thesteambuttonhgeneratessteamfor
foamingorwarming.
6Steamdispensingdial
Hotwaterorsteamcanbedispensedby
turningthedialtog orh.Todispense
steam,thesteamgenerationbuttonh
mustbepressedrst(see“Steamforfoam
ingmilk”).
7LEDdisplay
ThevariousLEDsindicatethefollowing:
Hon Thewatertankisemptyand
needstobelled
Ion Traysfull:
Emptyandreplacethem
Iashing Traysmissing:
Reinsertthem
S on Runtheserviceprogramme
(see“Serviceprogramme”)
S ashing Serviceprogrammein
operation
Jon Turndialtog/h
Jashing Turndialto“O”
Settingsanddisplays
Settingthewaterhardness
Itisimportantthatthewaterhardnessbe
setcorrectly,sothattheapplianceindicates
accuratelywhenthedescalingprogramme
shouldberun.Thefactorysettingisawater
hardnessof4.
Youcancheckthewaterhardnessby
askingyourlocalwatersupplier.
Degree Waterhardness
German(°dH) French(°fH)
1
2
3
4
17
815
1623
2430
113
1427
2842
4354
Theappliancemustbereadyforuse.
● Holddownthesteambutton
hforat
least5seconds.ThenumberofLEDs7a
H,bI,cS,dJthatlightupindicates
theselectedwaterhardness.
● Pressthesteambuttonhrepeatedly
untilthecorrectnumberofLEDsislit;e.g.
forahardnessof3,theLEDs7a,bandc
(H,I,S)lightup.
● Pressthebutton2âonce.Theselected
numberofLEDsshouldlightupbriey;
thisindicatesthatthedesiredsettinghas
beensavedsuccessfully.
Ifawaterlter(optionalextraOrderNo.
461732)isused,thewaterhardnessshould
besetto1.
Note:Ifnobuttonispressedwithin
90seconds,theapplianceswitchesto
standbymodewithoutsavingthenew
settings.Inthiscase,thepreviouswater
hardnesssettingisretained.
Theappliancemustberinsedwhenalter
isrstusedandafterchangingthelter.
● Fillthetankwithwateruptothe“0,5l”
mark.