Care and Maintenance en-us
43
To check or clean the filter system:
1.
Unscrew the Large Object Trap as
illustrated and remove the entire
filter system.
2.
Remove the microfilter from the
fine filter for easier cleaning.
3.
Rinse the filters under running
water and use a soft brush to
clean.
Note: do not use abrasive
brushes or steel wool, etc., as
they may damage the filter.
4.
Reinstall the filter system in
reverse sequence and lock into
place by screwing the Large
Object Trap until the marking
arrows align.
Spray arms
Check spray arms 1:, 1Z for
grease and limescale deposits. If you
find such deposits:
■ Fill detergent dispenser 9: with
detergent and start the appliance
without utensils in the cycle with
the highest rinsing temperature.
~ "Wash Cycle Information"
on page 33
■ Clean the appliance with
detergents/appliance cleaners
which are particularly suitable for
use with dishwashers.
■ Unscrew the upper spray arm
1: and pull off the lower spray
1Z arm as shown. Inspect for
deposits.
To Next Page
Loading...
Need help?
General
