Installation
23
Uni Condens 8000 F – 6720867056 (2016/10)
6.11 Attaching the data plate
The data plate can consist of up to three parts:
• Data plate containing the brand and product type of the boiler
• Data plate containing the technical data
• Data plate containing explanations of the abbreviations in the
language of the country concerned
Fig. 19 Attaching the data plate
[1] Data plate containing the brand and product type of the boiler
[2] Type plate containing the technical data
[3] Data plate containing explanations of the abbreviations in the
language of the country concerned
6.12 Fitting and removing the front cover
▶ Hook lower front cover ( fig. 20, [3], page 23) into the holders on
the right-hand and left-hand side of the boiler casing.
▶ Hook upper right front cover [2] into the holders on the boiler casing.
▶ Hook upper left front cover [1] into the holders on the boiler casing.
Fig. 20 Fitting the front cover
[1] Upper l.h. front cover
[2] Upper r.h. front cover
[3] Lower front cover
▶ To remove the front covers, proceed in reverse order.
6.13 Fitting the control unit support and cable conduit
For on-site cables:
▶ Install separate cable holder systems.
We recommend fitting the control unit to the same side as the door
hinges (factory-fitted on the right).
▶ Mark the installation height of the control unit support
( fig. 2, tab. 5, page 8).
▶ Trim and mark the cable conduit ( fig. 2, page 8).
▶ Drill holes (Ø 5 mm).
▶ Secure the cable conduit with the self-tapping screws supplied.
▶ Secure the control unit support ( fig. 21, [1], page 23) with the
self-tapping screws supplied.
Fig. 21 Fitting the control unit
[1] Control unit support
0010014779-001
2
1
3
0010014762-001
1
2
3
0010014742-001
1
To Next Page
Loading...
