Bosch Uni Condens 8000 F - Page 30

Control unit
Uni Condens 8000 F – 6720867056 (2016/10)
30
▶ If available, affix module label to the back panel.
▶ Observe service instructions of the control unit.
▶ Fasten back panel ( fig. 34, [4], page 30) to the base of the casing
[3].
Fig. 34 Fasten back panel to the base of the casing.
[3] Separate the back panel from the base of the casing.
[4] Rear panel
▶ Make the plug-in connection in the control unit in accordance with the
labelling on the terminal strip.
▶ Connect the burner cable to the control unit in accordance with the
labelling on the plug-in strip.
▶ Make all electrical connections to the appropriate plug-in connectors
according to the wiring diagram.
▶ If available, connect communication ports of the user interface.
▶ Set the control unit address
Fig. 35 Set the control unit address
[1] HMI
0010004448-001
4
3
0010011783-001
+-
3 2 13 2 1
2 1
J1
LAN1
USB1
LAN2
J2
1
2.
3.
1
1.