Bosch WDU8H541GB - Page 50

en Troubleshooting
50
Fault Cause and troubleshooting
Drum jerks after the
programme starts.
This is caused by an internal motor test.
▶ Not a fault – no action required.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Too much detergent/fabric softener in the detergent
drawer.
▶ When dosing liquid detergent and fabric softener,
observe the marking in the detergent drawer and
do not dose above this.
Fluff on the laundry. Fluff has accumulated in the drum.
▶ Run the Drum Clean programme without any laun-
dry or detergent.
Fabric softener re-
mains in the detergent
drawer.
The use of fabric softener is not supported for the se-
lected programme.
▶ Before washing, check whether the use of fabric
softener is supported for the selected programme.
→"Programmes", Page26
The laundry is too
damp.
Unsuitable programme for the type of fabric.
There has been a power cut.
▶ Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
1. Remove the laundry from the drum as soon as the
drying programme has finished.
2. Spread the items of laundry for cooling.
Drying target not adjusted.
Load too small.
Water tap is closed during the drying phase.
▶ Make sure that the water tap also remains open
during the drying phase.
The ambient temperature is greater than 30 °C.
▶ Ensure that the ambient temperature is below 30
°C.
Insufficient air circulation at the appliance's installation
location.
▶ Ventilate the appliance's installation location.
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.